Discussion in 'the CleAn Room' started by Mikey P, Apr 11, 2018.
Just the exterior.
Has Miagi San figured it out yet?
I was done before I asked
But not happy with my technique
Not your first strip and wax? How did it turn out?
You need to burnish the floor uhs to make it pop
Burnishing sort of melts the wax, settling down the highs and streaks?
Yes sort of
Makes the wax harder too , helps it keep the shine for custy
Because you have low humidity and doing it in the middle of winter with even lower humidity. If you are doing a sizable floor you have to pay attention to your overlap. If the finish starts to dry before you start your new line and you overlap you will pull or drag the previous finish (it will look terrible). Might not have been technique issue but fighting temperature and humidity.
Did you have a lot of cloudy areas or streaks?
Ya outside was cloudy and my undies were streaked!
Just use a real mop.
besides Sams issues streaks can also be caused through using old product or mixing new and old, some finishes can offgas if left sitting around and the solids dont seem to blend as well.
My terminology or explanation is possibly wrong but I don't like using old product or mixing new and old
Come on you’ve streaked once or twice?
yep like my post reads its offgassing causes it
So true it’s like sneaky shit!