Discussion in 'The Hardware' started by SamIam, Nov 19, 2017.
Ever tried it that way???
That didn't answer my question. What is your experience, or what are the truckmounts that you've owned that've given you problems?
Improper ergonomics have stunted more C Cers than anything. Most bend at the waist cause they don't let go of the follow/assist hand.
I also off set my handle. Makes it easier to pop up the wand at the end of the stroke.
I actually don’t offset the Devastator as per instructions of Tom.
But every other wand I own gets the twist.
Why not? Do you stroke differently?
It has to do with the swivel easier to control
My shop has 10 boxes of parts from my old hx machines. Our Hudson's (3) have 1 box with a few belts. Combined hours of about 11000 hours.
CDs direct drive 450 and 470 hydramaster, Genesis and a few I don't remember. Always diverters and electronics. If my employees can't run and maintain a propane heater and an engine they are too stupid to clean carpet.