Hydroforce Sprayer Issues

[Living The Dream]

My hydroforce injection sprayer will not quit spraying even when not keyed. I pulled it apart and cleaned the filters and screens but it didn't help. Any tips or troubleshooting advice greatly appreciated!

 

[Mikey P]

get a new trigger, if it can't be taken apart and dealt with individually.

 

[Living The Dream]

get a new trigger, if it can't be taken apart and dealt with individually.

Thanks Mike! I'll take a look tomorrow? What fails in the trigger? I'm guessing a spring or seal?

 

[Mikey P]

some guns are so cheap they can't be serviced.

sounds like you have a broken spring

 

[Living The Dream]

Can this valve assembly be bought individually?

 

[Living The Dream]

If you look closely at this picture you can see a busted seal, but where did it come from?

 

[Living The Dream]

Here is the seal after I pulled it out.

 

[Nomad74]

Ace Hardware $.30 fix.

 

[Living The Dream]

Ace Hardware $.30 fix.

It must seat in the bottom of that valve?

 

[FB19087]

valve

Replacement Valve for Plastic Spray Gun

Replacement Valve for Plastic Spray Gun

www.aramsco.com

or you can get the handle/trigger valve assembly for $37

Aramsco It is our pleasure to provide uninterrupted service to Jon-Don customers Equipping You For Success. The #1 source for equipment, chemicals, and supplies.

The Aramsco Family of Companies proudly serve the markets of: Restoration, Abatement, Professional Carpet Cleaning, Janitorial & Sanitation, Concrete Surface Preparation, & Stone Fabrication

www.jondon.com

looks like that 10 cent oring might fix you up though

 

[hogjowl]

It’s 30 cents in California

 

[Hack Attack]

only if you leave your change on the counter

 

[Living The Dream]

Tried several different O-rings today and it made things worse. I think they were to fat. I think I'll order the replacement valve and pull it apart to see what the proper seals and O rings are. Then I can have a rebuilt spare on hand.

 

[Nomad74]

Well, you tried

 

[FB19087]

Tried several different O-rings today and it made things worse. I think they were to fat. I think I'll order the replacement valve and pull it apart to see what the proper seals and O rings are. Then I can have a rebuilt spare on hand.

https://manuals.interlinksupply.com/Tile%20Cleaning%20Tools/100010%20Valve%20Repair.pdf

 

[Living The Dream]

https://manuals.interlinksupply.com/Tile%20Cleaning%20Tools/100010%20Valve%20Repair.pdf

Thanks Fred! Exactly what I needed!

 

[Jimmy L]

Just buy another spray gun from a car wash supplier.
www.dultmeier.com

Don't over think this

This isn't hard

Don't buy a overpriced gun from interlink

 

[Matt Middleton]

My hydroforce injection sprayer will not quit spraying even when not keyed. I pulled it apart and cleaned the filters and screens but it didn't help. Any tips or troubleshooting advice greatly appreciated!

As time passes, we try to have at least one replacement for every contingency possible. Butler parts, sprayer parts, belts, etc.

 

[Living The Dream]

Just buy another spray gun from a car wash supplier.
www.dultmeier.com

Don't over think this

This isn't hard

Don't buy a overpriced gun from interlink

I think they are more expensive at the website you provided but I'll check into it a little more. I think heat is what ends up causing these injection sprayers to fail. If they have better heat resistance it will be worth it

 

[steve_64]

I buy a new one every couple years. I get tired of fiddling with them.