Really dumb question about flow meter

[Bill Soukoreff]

Sorry, I know this is a really dumb question but I want to make sure so I don't have to mess around tomorrow:

Tonight I just installed a simple siphon chem draw on my TM. Tomorrow I have some wool to clean and I since sodium precarbonate does not mix well with wool, can I just turn the flow meter knob off to not draw chem and just leave the injector valve set the way it is?

 

[Guest]

If it is a siphon draw,then the only way to get it to pull is by opening the flow knob,so by closing it off it should not draw.

 

[Greenie]

Sounds like you are good to go. :wink:

No acid rinse in stock?

 

[Bill Soukoreff]

Sounds like you are good to go. :wink:

No acid rinse in stock?

No, I have never felt the need to use acid rinses. I just use a fresh water rinse on woo. Don't need to with the pre-spray I use. In fact this the first time I will be using a rinse period. I have a commercial job this week that needs to be HWE, and I want to some extra cleaning power.

When the O2 arrives, I will plan to always use it as rinse.

 

[Guest]

Bill,you might want to use an emulsifier on that