The lid on the Orbot Vibe has always bothered me. With wet hands or if there is any dried crud in the grooves, it's extremely hard to open. So installed the type of lid that's on my Penguin sprayer. I consider it an upgrade. You may think otherwise.
Orbot Vibe Lid "Upgrade"
- Thread starter Nomad74
- Start date
Nate The Great
Member
Too many turns to get it on or off.. 
Too complicated for ya?Too many turns to get it on or off..
Mikey P
Administrator
What does your wife think of you making these videos?
I have one of those lids on my fresh water tank and all I did was go to a hardware store and put a a cheap metal handle on top of it. No need to overthink this.
No need to make a dumb video
No need to make a dumb video
That's why I only make quality videos. Thanks for noticing
My wife is in Blackhawk at a tennis tournament. But she has absolutely no interest in my little hobbies. That's okay. I hate tennis.
Desk Jockey
Member
Damn Jimmy beat me to it. Add a handle to the old lid.
I actually thought about screwing a handle on the stock lid as you suggested. But I would most likely snap that off
not "Damon Proof Certified". Apples and Oranges.
