Oh pew... my church job tomorrow...

[BIG WOOD]

Ok, 11.5 hrs, AND I FOOKIN HATE WAX..... went through 1/2 gal of oil-flo.... and rinsed like there’s no tomorrow.... excuse me while I pour a drink....

What was your water pressure on your stair tool?

 

[Dolly Llama]

went through 1/2 gal of oil-flo

what's that, Jeff?
how did you address the wax while scampooing?
240 ATM makes short work of candle wax

I'd rather pound my fingers with a 20oz hammer than "hands 'n knees" juice and scrape

..L.T.A.

 

[BIG WOOD]

Another reason to use an internal jet pmf tool

 

[Kenny Hayes]

what's that, Jeff?
how did you address the wax while scampooing?
240 ATM makes short work of candle wax

I'd rather pound my fingers with a 20oz hammer than "hands 'n knees" juice and scrape

..L.T.A.

Is there another way except scraping?? Easter is a killer after Easter candle light vigil!!!

 

[Cleanworks]

what's that, Jeff?
how did you address the wax while scampooing?
240 ATM makes short work of candle wax

I'd rather pound my fingers with a 20oz hammer than "hands 'n knees" juice and scrape

..L.T.A.

You're in church. You're supposed to be on your knees.

 

[Dolly Llama]

Is there another way except scraping??

heat
Doesn't take a whole lot to melt wax

any TM that will make 160-180 can melt 'n flush it out with a PMF internal jet tool
any TM that can make 240 ATM can melt/flush rinse out with any wand that jets aren't a mile from the carpet

if using portys, I figure it would take some kind of heater that will sustain 160 at a decent flow rate

..L.T.A.

 

[jcooper]

jcooper said: ↑
pmf stair tool & glide would make quick work on those pews.
I tried using my prochem stair tool, and it was a pain. Good luck on that

The pmf stair tool is 10" wide and a swivel, prochem is what 4" wide? Of course it was a pain!

 

[Sierra Clean Care]

what's that, Jeff?
how did you address the wax while scampooing?
240 ATM makes short work of candle wax

I'd rather pound my fingers with a 20oz hammer than "hands 'n knees" juice and scrape

..L.T.A.

 

[greencc]

why use oil-flo for candle wax? it says it should rinse out with water, was that not the case?