Walt
Member
- Joined
- Aug 1, 2007
- Messages
- 1,016
The 360i runs well at 300 psi. My ti wand does not. It likes a min. of 400 psi.
I realize I can set the tm at 500 if I want and feather the 360i with the little valve. That's clunky and inaccurate. Or I can go back and forth between the machine turning pressure up
And down, which is slow. Maybe I could put a permanent flow restrictor on the 360i to
Reduce the pressure from 500 to 300.
Or I could just get a new wand for edging. Something with more impact at lower pressure.
I realize I can set the tm at 500 if I want and feather the 360i with the little valve. That's clunky and inaccurate. Or I can go back and forth between the machine turning pressure up
And down, which is slow. Maybe I could put a permanent flow restrictor on the 360i to
Reduce the pressure from 500 to 300.
Or I could just get a new wand for edging. Something with more impact at lower pressure.