Fresh water float valve options

Mikey P

Administrator
Joined
Oct 6, 2006
Messages
114,517
Location
The High Chapperal
I'm on my third Hudson valve on the Vortex..

http://hudsonvalve.com/

$38 each over ten years is nothing to cry about but would like something that can take the heat better.

A swing arm type valve wont live long as there are no walls or supports to keep it from bouncing all over the place.


1 inch pipe inlet from the side...
 

GeneMiller

Member
Joined
Mar 24, 2009
Messages
3,541
Location
Boca Raton
Name
gene miller
I have a holder for my float. It prevents it from bouncing up and down. It holds it just below the full mark.
Has worked so far. I also took the plastic arm that was breaking and made a new one out of aluminum. The holes that the stainless cotter pin runs through are getting bigger and it will eventually fail but it has already lasted 4 times longer. I have a Hudson but never bothered to run the extra plumbing to make it work. It did fail today but I haven't looked. The float might have just come off.


Gene
 

GeneMiller

Member
Joined
Mar 24, 2009
Messages
3,541
Location
Boca Raton
Name
gene miller
Post a picture of it, or better yet make a video. Lol

Gene
 

GeneMiller

Member
Joined
Mar 24, 2009
Messages
3,541
Location
Boca Raton
Name
gene miller
Can't believe that the float broke after just talking about it. The little ear broke off. Time to plumb in the Hudson

Gene
 

Latest posts

Back
Top Bottom