I'm no Middleton, but I pulled it off.

[Mikey P]

While wanding a office on Friday I single handed a chair across the room.

The vac hose was against it so I did not pay attention the resistance....

Woops.

The Stainless caster was long gone.

7 or so feet of damage and lots of small pulls from the staff.

I went back today and did my best SA impersonation. I talked to the fibers telling them yarns from my twisted youth. Gently massaging them back into their new beds of Latex and Poly. Then stabbing them in the head so they would never run off again.


No one will ever know but you all.

 

[bob vawter]

Thank God for George.....

 

[Greenie]

didya learnt that from George's DVD?

 

[Guest]

betcha he's got a set of Georgie knee pads

 

[Mikey P]

DAD!!!!!


Their picking on me again!!!

 

[Jack May]

Awesome Mikey.

John

PS I haven't seen my commission this month yet and I need to buy my kids some pressies

 

[Bill Soukoreff]

That is awesome. I got to learn how to do that!

 

[Jack May]

Chimps would have been fired if he'd done something as thoughtless as that, so what did you get?

John

 

[Able 1]

Great work Mike! I need to learn how to do that... I just can't see me trying this at a custy's house I'll have to practice on the rentals..

 

[Shorty]

Wotta buncha dummies.

It'z not hard, nor is it rocket science

Just rip a caster off the chair and slide it across the room, it'll rip chuncks out easy enough.

Duz I gotta come over there and show yews :?:

Ooroo,





PS ::: Just like Jorge, I see you put some in backwards, eh :?: :wink:

 

[Larry B]

Great work Mike! I need to learn how to do that... I just can't see me trying this at a custy's house I'll have to practice on the rentals..

Just go to a carpet store and get some free cut offs to work on. Its very easy to do

 

[Mikey P]

Very easy indeed.

 

[Larry B]

After you noticed what you had done did you kick the crap out of the chair?

 

[Jeremy]

Way to CYA... Hack :!: :wink:

 

[bob vawter]

REMINDER:
This is NOT the board to be sayin' that....

You pulled one off..........!

 

[Ron Werner]

thats what sliders and sticky tabs are for

 

[Stevea]

Mikey,

I have been gone a lot lately and what a neat repair to see when I open the board up, everyone here should be proud of you.
Great example to share. It is good to be able to fix something like this, never know when it may arise.

SA