cleanman71
Member
Has anyone owned a Judson TNT? How did it hold up for you?
Judson TNT
- Thread starter cleanman71
- Start date
Mikey P
Administrator
So simple that a Texan could figure it out.
The Little Giant heater may give you some fits once in a while.
The Little Giant heater may give you some fits once in a while.
Mikey P
Administrator
Little Giants were created to heat baptism pools on Sundays. The constant on off and relighting we give them creates a lot of maintenance work, on Sunday...
GreenTechAgain
Member
Love mine. Paired with a Northstar diesel burner. I clean a lot of T&G.
Judson all pros.
Northstar, pros and cons.
Judson all pros.
Northstar, pros and cons.
Mikey P
Administrator
Very similar to the Tnt for sure.
Some pros and some cons but both will serve you well
BradFenstermaker
Member
I bought a used TNT a few yrs ago. I have enjoyed it. Because of its age but low hours I have replaced engine and cat pump. They are built to last IMO. Love the design.
Little Giant only takes about 30 mins tops about every 3 months to clean the burner ring. Most of the time its a 15 min job.
They are very hard to find if your searching used.
Just like any TM if you work them hard they will need some lite maintance/repairs occasionally.
I like that most anything that goes wrong I can fix myself. There is no fancy solenoid or exchangers to deal with.
Engine, Blower, Pump and there belts.
Ignition switch is the most complicated piece on them. LOL
Little Giant only takes about 30 mins tops about every 3 months to clean the burner ring. Most of the time its a 15 min job.
They are very hard to find if your searching used.
Just like any TM if you work them hard they will need some lite maintance/repairs occasionally.
I like that most anything that goes wrong I can fix myself. There is no fancy solenoid or exchangers to deal with.
Engine, Blower, Pump and there belts.
Ignition switch is the most complicated piece on them. LOL
Mikey P
Administrator
Brad is far more mechanical than I
But my eyebrows grew back..
But my eyebrows grew back..
Last edited:
cleanman71
Member
Thanks for the input. That helps me narrow it down.
Nate The Great
Member
I thought you had a Century400 Avenger210? When did you get a Judson?
What happened to the LG, freeze? One of my coils to an older #3 blew twice.. My friend did Silver solder it for me, but it's close to the burner ring so it heats up too much in my opinion...
I'm used to using LG heaters, so a Judson would be my choice.. With that in mind, if I did switch machines, I'd be looking at a SS870 or PCEverest650... So I wouldn't have a separate fuel source...
