Rotovac 360i quad head

[FB7777]

Occasionally I get swirl marks on CGD that will not come out.

Fortunately they are barely noticeable, but I see them and if a customer does I am at a loss for how to explain these permanent marks

I've tried following with wanding, rx20 and bonnet with no improvement.

Only clean these accounts with a wand and RX20 which I never have had issues with

Anyone using glides with their 360?

Cause I'm about ready to unload it on eBay before I run into a real problem

 

[Nate The Great]

How much?

I've only noticed the pile reversal where I overlap.... I use my Zipper on CGD...

 

[Kellie Hiler]

The only time I use the Rotovac on CGD is in two of my restaurants and I use the brush head because they need the agitation. I've never noticed any swirl marks.
I use the Zipper on the rest.

 

[Charlie Lyman]

I never use it on CGD. I wonder if it's causing friction damage?
If I need the agitation I use the 175 and brush. It does a better job than the RV.

 

[Mikey P]

Never caused it but seen it..

Friction burn?



Red pad and Zipper

OrCimex tis the answer

 

[wilpath]

roto is uncool now?????

 

[Shorty]

I wouldn't say the "Roto" is uncool, in fact, I have NO HESITATION, in saying it's the best rotary that I have ever used IN MY BUSINESS.

Be this on my truck mount or portables.

Fred specifically quoted the QUAD HEAD.

I never had a problem with my 15" QUAD HEAD, (which incidentally, was recently stolen along with my T & G head and surround).

I did stop using the 15" QUAD HEAD purely because I had suspicions that it was too big a drag on the smaller motor that my 360i has.

My standard 12" x 3 port head, has saved my bacon many times.