Wand Jet Question.

[Ryan]

So I've got this wand an old 1.5 inch tubed 12" one. I needed new jets for it and ordered some. When I got them in the threaded part was too small too screw in. I wasn't aware there where different sizes for the threaded end on jets. These seem slightly larger then the standered size. Do I need to measure something? Or does anybody know what size these might be? Thanks.

 

[J Scott W]

1/4 inch are the most common. A few are 1/8 inch.

Look at the end of the jet where the spray pattern and flow rate are stamped in. The size should also be there. Some 1/4 do not put the size on the end, but I have not seen any 1/8 that don't have the size stamped in the spraying end.

 

[truckmount girl]

Funny, our customers are 95% 1/8 vee-jet guys. We don't even stock 1/4" anymore. All stainless too, don't carry brass.

Take care,
Lisa