Mikey P
Administrator
Hot water heater in our home went out and I cant get it to re light..
Anybody know anything about this Honeywell ignighter?
- Thread starter Mikey P
- Start date
F
FB19087
Guest
Hold the knob in the pilot position
press igniter button (square one) until it lights
release the knob
some other issues like faulty gas control unit mentioned in comments
press igniter button (square one) until it lights
release the knob
some other issues like faulty gas control unit mentioned in comments
Last edited by a moderator:
Mikey P
Administrator
Yeah...
Tried that ten rimes.
Tried that ten rimes.
F
FB19087
Guest
yeah...that is what all those other people said.........and I know how you like to skip steps
but the comments on vids like that are much more likely to lead you to a solution than asking here
but the comments on vids like that are much more likely to lead you to a solution than asking here
KevinD
Member
Take the red and white wire and attach a meter to it.
It needs to read at least 350 milivolts while you have the pilot button depressed and lit.
If not the thermopile is bad.
In a pinch I have removed them and polished them with sandpaper to transfer more heat.
There may also be a reset able thermal switch down by the sealed burner
It needs to read at least 350 milivolts while you have the pilot button depressed and lit.
If not the thermopile is bad.
In a pinch I have removed them and polished them with sandpaper to transfer more heat.
There may also be a reset able thermal switch down by the sealed burner
Mikey P
Administrator
Hula figured it out...
Zee
Supportive Member
That dog looks like it is ready to maul you.. with that disgusted "wtf you lookin at hooman?" look.
Last edited:
