Judson 02 prespray

[vincent]

Who uses it in a hydroforce and what are your fix ratios?

Also do you apply it at the same psi you clean with?

 

[ACE]

Mikey,

Can you make a room dedicated to questions about Judson Jizz?

 

[Out of Character - 0]

For us, usually 16oz per 7qt sprayer 1:4 (no tip) applied @ 800psi unless it's a really dirty then 500psi draws better, I'd go to 300 if I was treating a bad spot but usually it's better to make a stronger mix and save the time @ 800psi.

We soak em so psi save lots of time

I also add things to it besides the modifier.... It's compatible w/ everything I like to boost with.

 

[Wandslinger]

8 to 10 ounces for one gallon of water in the Hydraforce, 500 PSI and no tip.

 

[daniel@procarpet]

Is the JJ thick like Ultrapac? It must be for only 8oz in hf.

 

[sweendogg]

Yes its thick.. shake well before pouring and before using in the HF. we use 16 oz at 4-600 for most jobs. If I think it needs the Hot Sauce I'll add five heaping teaspoons. It has taken care of everything I wanted it to when I use it. If its really dirty and I know ahead of time, I'll go nuclear on it with Grease Eraser or other high pH like powerburst, enzall, etc..

 

[Ron Werner]

I mix a 10liter jug with 16oz of O2, pour that into a HF jug with a yellow tip (1:8), apply with around 500psi

 

[Shane T]

8 to 10 ounces for one gallon of water in the Hydraforce, 500 PSI and no tip.

Ditto! Notice this without a metering tip. With this setup it even pulls chem at 200 degrees.