Titanium wand jets,

[steamron]

I have a Prochem titanium wand, wondering if anyone one changed up the jets to fit their needs or preference. What are they?

I don't like the slight over spray one each end.

 

[Dwain Ray]

I have a Prochem titanium wand, wondering if anyone one changed up the jets to fit their needs or preference. What are they?

I don't like the slight over spray one each end.

On most of my wands i found if you slighty angle the jets you can eliminate overspray and streaking (in the middle where 2 jets spray patterns hit one another)

 

[BIG WOOD]

I think 80 degree jets are good if you don’t have jet extenders. What’s the current angle on the outside jets?

 

[Kenny Hayes]

Even the old Jimmy Bane wand would do that at 150 psi

 

[SuperiorF]

I have a five jet wand. I purchased it used it came with five 80015's. Does this sound right? Any suggestions? I believe it may be a prochem>

 

[Mikey P]

8001- 9501-11001-11001-9501-8001 for six flow and no extenders

 

[BIG WOOD]

I have a five jet wand. I purchased it used it came with five 80015's. Does this sound right? Any suggestions? I believe it may be a prochem>

The only wand I know of that’s a 5 jet is a pmf mach15

 

[BIG WOOD]

80015= 80degree spray and 1.5flow x 5= 7.5flow of water

 

[SamIam]

I have a Prochem titanium wand, wondering if anyone one changed up the jets to fit their needs or preference. What are they?

I don't like the slight over spray one each end.

Four jet would probably be 11002 in the middle and 9502 on the ends.

6 jets would the same except add two 9502 in the other ports,

In the 6 jet you could drop to 9501.5 and 11001.5 jets to reduce to 9 flow instead of 12 flow.

 

[SamIam]

The only wand I know of that’s a 5 jet is a pmf mach15

Well the jet is off the carpet if it's the mach 15 with no extenders so that's probably good.

You can tell if it flushes good or not and make changes if needed